Pass Your Juniper JN0-360 Exam Easy!

Answer to Max - There are no simulations in the JN0-360. It is just a written exam much like ITIL and CCDA etc.

Hello my friends.

I am CISCO guy so new to Juniper. Do I have to study some LAB simulations as CCNA and CCNP to pass JN0-630 ??????????

Thank you a lot

Valid, about 10 new questions.
Passed with 78% Score.
Check the correction here for wrong answers.
As I saw there is more wrong answers because I did all the same but still had more than 10 wrong answers if we assume all of them are wrong (but they wasn't) so need to check the answers carfully where are the mistakes, but even with this mistakes you will pass.

The damp is still valid. Passed today at 71%, not all the questions are right and around 10 new questions.

dump still valid. Around 4 -5 new question but there area some wrong answers in this dump

Dump Is Valid. Today I have Passed with 72% mark.
Keep In mind following Thinks
1. This Dump can make sure that you will Pass but do not bring Good marks.
2.Some Question answer are wrong.
Compare With http://www.doc88.com/p-683406753791.html and http://www.docin.com/p-280617483.html File name is "JN0-360.V10.2"
4. At Real Exam the Answer Option Order is Changed compare to Dump, So keep in mind what is right Answer instant of remembering the answer order.

Best Of Luck

Dumps are still valid. Passed on 10/22/2012 with 81%. Got 10 new questions BUT around 5-10 questions are wrong in this dump.

Valid.. about 5 new questions.
This file has many wrong answers.. below are the correct options.
Which two configuration elements must match on all switches participating in the same MSTP region?
Correct Answer
B.
D.
What are two benefits of using an OSPF designated router (DR)?
Correct Answer
B.
D.
Router A receives two similar route advertisements from different BGP peers.What would cause a route to be selected in this scenario?

correct Answer is
A.

which statement is true?
Based on the illustration of the VPLS topology shown in the exhibit, which statement is true?
correct Answer is
A.
PE-C must have a spanning-tree protocol enabled

You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the locally connected CE router's interface. The address of the interface is 192.168.1.1; the VPN routing-instance is named VPN-A.Which command will accomplish this task?
Correct answer
A.
ping routing-instance VPN-A 192.168.1.1


You work for the regional Internet service provider shown in the exhibit You have a partial BGP table and are receiving a 10 100/16 route from your upstream ISP You have been asked to configure a default route that can be sent to your downstream customer This route should forward customer traffic toward your upstream Tier 11SP as long as the 10.100/16 route is present.

What would accomplish this goal?

D.
Create and announce a generated default route

Hey khan, how many percent score did you get?

valid, 10-13 new questions.