Recent content by jeremySanDiego

J
possibly fried CPU or MB?

well, it cannot be blown, or I wouldn't have buzzed it out.. so.. try a new PSU? will seasonic repair/replace the current one?
- jeremySanDiego
- Post #13
- Dec 15, 2005
- Forum: Computer Building
J
possibly fried CPU or MB?

fuse IN the power cable? I didn't realize they have fuses. I didn't see any and all the lines buzz out <1 Ohm.. jeremy
- jeremySanDiego
- Post #11
- Dec 15, 2005
- Forum: Computer Building
J
possibly fried CPU or MB?

Okay, gettiing 0V on every pin. Shorting GRN to ground does nothing. I have every power sink disconnected (except fans). So, Do PSUs generally have warranties to cover all uses? I really don't think the power supply would die like that. Isn't this uncommon? thanks, jeremy
- jeremySanDiego
- Post #9
- Dec 14, 2005
- Forum: Computer Building
J
possibly fried CPU or MB?

The asus manual says clearing CMOS isnt necessary after a shutdown due to overclocking. It says there is a CPU parameter reset feature that just requires a reboot. I did it anyway, along with reseating the CPU and I still have nothing.
- jeremySanDiego
- Post #5
- Dec 13, 2005
- Forum: Computer Building
J
possibly fried CPU or MB?

reseat or reset?? How do you reset the CMOS?
- jeremySanDiego
- Post #3
- Dec 13, 2005
- Forum: Computer Building
J
possibly fried CPU or MB?

I normally overclock 103% (been running for months). I left my computer on @108 and it went off overnight. Now the power supply doesn't go on. Doesn't it need a signal from the MB to turn on? I tried disconnecting various power sources, but that is no help,eh? Is there a way to tell if I fried...
- jeremySanDiego
- Thread
- Dec 13, 2005
- Replies: 13
- Forum: Computer Building
J
a8n-sli "premium" edition

So, everyone else can get 5.1 digital out ok?? using the ASUS util, you can hear all 6 channels?
- jeremySanDiego
- Post #248
- Jun 30, 2005
- Forum: Motherboards
J
a8n-sli "premium" edition

flibidyflob, "Did you use the speaker setup utility (test sounds) in the Realtek soft so that you know you have the speakers plugged correctly?" plugged in? I am using spdif to my receiver. "Is what you're listening to actually 5.1?" I am using the ASUS speaker utility. You can...
- jeremySanDiego
- Post #246
- Jun 29, 2005
- Forum: Motherboards
J
a8n-sli "premium" edition

Sorry, should have mentioned: 1. realtek is installed. 2. sound mgr untility set to 6CH, didn"t help 3. control panel shows 5.1 sound on the realtek, driver reports working properly Kman, I am no where near an expert, but i cn try and answer your SPD question. Short answer: SPD =...
- jeremySanDiego
- Post #242
- Jun 29, 2005
- Forum: Motherboards
J
a8n-sli "premium" edition

I can't get 5.1 sound out the MB. Only 2.0.. but reciever works fine on 5.1 source. Any ideas?
- jeremySanDiego
- Post #237
- Jun 29, 2005
- Forum: Motherboards
J
Need help with MCE RAID 0 install - crashes on boot

just restarted from scratch and now windows saw one 140mb disk.. we'll see how this goes
- jeremySanDiego
- Post #7
- Jun 25, 2005
- Forum: Operating Systems
J
Need help with MCE RAID 0 install - crashes on boot

I probably won't be doing any recording for awhile, I can buy a bigger HD later. At this point, I own two 74 raptors and would like to get raid 0 working. Yes, the MTBF is halved, I am ok with that. If I even get a little performance inprovement, I am happy. Now, I am assuming I should see...
- jeremySanDiego
- Post #6
- Jun 25, 2005
- Forum: Operating Systems
J
Need help with MCE RAID 0 install - crashes on boot

so why is mce raid 0 pointless? anyway, got an OS up by installing both drivers. But two issues: it couldnt fine iexplorer.exe on any disk given, and I dont appea to have the full raid. C: driver shows 80mb, but device mgr shows 160mb stripe??
- jeremySanDiego
- Post #4
- Jun 25, 2005
- Forum: Operating Systems
J
Need help with MCE RAID 0 install - crashes on boot

I am using an ASUS A8N SLI-Premium MB. My install fails to boot. Here are some observations: 1. my BIOS doesn't show the HDs (WD raptor 78 (2) ) when I use the Nvidia BIOS to config RAID 0. But when it is booting, it shows the 150+MB RAID when it gets to the nvidia BIOS section. normal, I...
- jeremySanDiego
- Thread
- Jun 25, 2005
- Replies: 7
- Forum: Operating Systems

RESOURCES

Top Bottom