i report the same issue after secure erase and abouth 1 month, used for OS and data.
0 respond from hynix, no firmware upgrade, nothing ..... very disappointed :(
@Jimminy
hi, i used this setting on my rtl9210B chip based enclouser, the result was a turn on/off loop of the device.
The EN_U1U2 set is not present in my default config file so i tried to add it.
Did you flashed the device with sdd inside the enclouser ?
hi,
i use an sabrent EC-SNVE enclouser with WD Blue SN550 nvme.
The enclouser is updated with FW 1.32.16
The idle temp of the nvme is about 43°C with 30°C room temp, is normal or a bit warm ?
the config file has DISK_IPS_THRES : 0x01 so the power saving shoul be on ?
What do you think ?
hi
is there an option to turn off the power completely to the enclouser when the pc goes to sleep or is turned off? These days I tried with the bios settings (erp, remove power from all usb ports etc ..) but the type-c port continues to be powered.
I thought it could be something related to...
hi
I flashed the Firmware 1.29.12 on EC-SNVE (RTL9210B based)
When there is activity the blu led flashing fast, while when there is not activity operation, the led flashing slow.
Is a low power mode operation indicator ?
@fantom3l
thanks
In the *.cfg from sabrent the serial is
SERIAL = "631345678939"
I get info of my enclouser with dump info and the serial is different.
what SERIAL i must uso to flashing the firmware ?
Is there any DISK_IPS_THRES suggest value ?
thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.