These have been out for years under the name 'Chill Wizzard'. They do work very well. It is a tailgate trick for when the beers are not cold... put a warm one in an ice bucket, spin it for a minute or two, then serve.
No idea how the physics around it work, but it does. I believe we had bad...
An XP1800. Nothing special. The entire batch is going like that. I had about 20 of that batch on this rig... it flew through them. Poor poor hit numbers though.
ShrikeAR
Wow. My other rig did 30+ jobs yesterday. Most had 0-3 hits. The high had just 8 hits. Good for the job count, bad for the hit count.
Just dumped them.
Thx for the stats, Bit!
ShrikeAR
I just had a string of ultra-fast low hit jobs. Six of my last seven have been sub-20000 seconds. Quite a change coming off a week of 150,000+ second runs.
I dumped a few today... should show up for tomorrow.
May be adding another rig soon. Upgrading my main rig to something like a 2400, and have enough parts laying around to keep the 1700 up and running.
I see others speaking of that software they use to control rack nodes. What is it? Is it...
I'm no doctor, but this is going to hurt.
............................... New Molecules ........ New Jobs ..... New Hits ......... Total Molecules ..... Total Jobs ..... Total Hits
Crazee .......................................... 0 ........................ 0 ................... 0...
XP1600 + XP1700 full time, except when I am on them.
XP2000 once in a while. Like when GEOBOT starts to catch up!
Had a -lousy- week. Actually cancelled two tasks. Both went up to about 30 percent, stopped, then went to 300,000+ seconds without moving the percentage... with single digit...
Arrrrr.... you thought I was sleeping! I may have a few weeks of downtime here soon (moving), so you will likely fly past me.
I have been getting more & more of these 'run forever' batches. When I started FAD 10-13 jobs daily was the norm. Now 8 is a great day, with the norm being 4-6.
Mmmmm... welders... cheap. Something about watching Monster Gargage that just makes you NEED a welder.
$99 for the ARC-140.
Been living with JB-Weld up until now. JB-Weld is the wonder-compound, but it does not make bright sparks fly around when you use it.
Must.... resist... ---mouse...
Adding a pair of AMD XP's to the mix... 1800 & 1600.
What is the most efficient way to execute this? I want zero effect when actually using my PC.
If I run it hidden I would like to see it at IDLE priority. If that is the best mode, then can anyone tell me how to default it to idle priority...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.