I have room behind the front cover of my Antec case to use a piece of 1" thick fiberglass funace filter cut to fit. Very cheap and takes forever to clog enough to restrict airflow.
http://www.trendmicro.com/vinfo/virusencyclo/default5.asp?VName=WORM_MSBLAST.A
http://securityresponse.symantec.com/avcenter/venc/data/w32.blaster.worm.html
A couple of links with Blaster removal instructions.
I mentioned the CDRW (CD read/WRITE) thinking you may want the ability to burn your own disks. Or a DVD R/W would be even better.
By the way, I have the same MB and CPU. Nice system.:D
http://www.zalman.co.kr/usa/product/cnps7000a-alcu.htm
Near the bottom of this page Zalman shows you what to look for on a socket 462 mb.
You must have greater than 55mm (2.1654 in) between the center of the CPU and the power supply. 2 1/4 inches will work.
Krueger81
I had the same problem with a slight oc. The problem was that with the DRAM Frequency set to Auto, it used a 3:2 divider. Changing this setting to 400 MHz gives you a 1:1 divider. This brought the bandwidth benchmark scores up to where they should be. THis setting is in the bios...
So... I wasn't the only one with wierd problems. I installed a p4p800, p4 3.0 and 2x256 Kingston Hyper X 3200.
At startup I often got the message " system failed due to overclocking". The thing is I wasn't overclocking. So I overclocked it to 3.3Ghz. No problem. If I set the "perfomance...
I just upgraded my system with a P4P800 Deluxe, P4 3.0 and 2/256 of Kingston HyperX DDR400.
When I ran MemTest 86, I never got through a single pass before MemTest would hang. Tried the usual swap out ram, etc. and always had this happen. I had about decided to RMA the board.
As a last resort...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.