Hello, i dont know much about overclocking. I know you have to increase the FSB Freq. in Genie BIOS...but when i increase it past 222mhz it doesnt boot. (just keeps restarting) here is my system:
DFI Lanparty UT nF3 250Gb
AMD 64 2800+ stock cooling @ 1.8, OC'd to 2.0ghz but cant get higher...
Depends.
A 802.11b wirless connection is slower than a 802.11g. An 802.11G only has a MAX transfer rate of 50MB a sec...you only get that if you are within 50 feet of the router. In my opinion, if you can live with out the wireless i would go with wired. With wired, and you have your router...
Hardware:
DFI Lanparty UT NF250gb
AMD 64 2800+
ATI Radeon 9800 Pro AGP
768 Kingston Value Select Memory
Maxtor Atlas 10k IV SCSI drive
Intio ini-9100uw SCSI host card (PCI)
Yes, the hardrive jumper is set to terminated power. It goes straight into the host card, this drive is the only...
I have a SCSI controller card in my pci slot...basicly i want to use my Atlas drive for my OS and my IDE drive for storage. By the way, i dont know much about SCSI. Can someone help me configure it? The jumpers are set at TERM POW and SCSI ID 6 i think. But when i load the driver for the SCSI...
OK...so i bought my lanparty mobo from newegg, and i got it friday. Everything went right in, started right up no problem. Installed the drivers, but when i went to get on the internet to check for BIOS updates i found that my lan wasnt even working. I noticed that the driver is installed but in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.