I'm using Kingston PC5300 and all voltages are normal. I haven't even started overclocking anything. I'm only attempting to get a running system at this point. I upgraded the bios to F7 (since it was F2 when I bought it) but I haven't tried optimal defaults in the bios. I'll try that tonight.
My PSU is 400W, but I don't understand why I would need to upgrade that to make this work. I have the computer hooked up to a KillAWatt and the whole computer is consuming less than 150W at full load, so I'm certain that even if I have a very inefficient PSU, I'm not hitting any limits. The...
I'm sick of this board already. I just can't get it to work with windows. I've reinstalled about 10 times doing it different ways each time: using F6 preinstall method with various versions of Jmicron driver; slipstreaming various jmicron drivers into the setup cd; installing on a Raid 0 on...
Thank you. I'll try the install again with the original Jmicron (since it does install properly) and then install all the latest drivers from the website. Hopefully that will work.
I've been searching through this thread and have seen some people complain about the problems with drivers for the various SATA ports, but I have not see any solution that actually works yet. I'm curious though why some people have problems and others don't.
Basically my problem is the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.