Search results

  1. B

    Samsung Galaxy S6 hype thread

    Just a side note here as I notice folks are down on the HTC One M9, I have 1, got it 2 days after release. Battery lasts all day, shut it off every night around 11 at night with at least 33% battery left and have never felt the phone get hot. Seems to be 0 throttle problems to date as well...
  2. B

    Water Water Everywhere...

    In a word, Yes. When Real Temp was being created after discussion with the founder I did exactly that with an old chip and board. I used a thermal gun and it buried the temp in under 15 seconds. So yes, they get hot fast. What I would do is pull all the components, spray compressed air under...
  3. B

    Think my PSU died - OCZ-GXS850

    Have you tried different power cables from the psu to the vid card yet, 1 at a time to rule out a bad/flakey connector? Also when you change the other supply and then the OCZ supply do you change the power cord to the psu cord as well or just using the same cord again for the next supply? Larry
  4. B

    Think my PSU died - OCZ-GXS850

    Yes it sure is a hard one to figure out.The cpu I take it isn't running too hot either.Seems you have covered the base's pretty well, I think I would order the new PSU at this point. Larry
  5. B

    Think my PSU died - OCZ-GXS850

    Well that being said I would check to make sure the fan is in fact working on the PSU and if so put your hand over the exhaust of the psu fan and see how hot the unit is running. I would also check to see how hot the vid card is getting too. Larry
  6. B

    Think my PSU died - OCZ-GXS850

    ^ Thats a good unit in the link IMHO. Larry
  7. B

    Think my PSU died - OCZ-GXS850

    Well I understand that but I was refering to the header on the board that the wires from the power switch connect to. You can pull the connection and jump the header where the wires were on very quick like to start it up, thus eliminating the switch. Larry
  8. B

    Think my PSU died - OCZ-GXS850

    Well the Power switch on the case is just a momentary switch so I guess it could be bad though this never happened with any setup I worked on. You "Could" pull the connection off the Power switch header, (on the board), and manually jump the 2 prongs with a screwdriver or the like to rule the...
  9. B

    Think my PSU died - OCZ-GXS850

    If this were me I would look real hard at the Mobo, check for bulging Caps, burned or brownish looking areas on both the front and rear of the board. Same for the Video card.It sounds like a short to me. Larry
  10. B

    Anyone still using LGA 775 as part of their main rigs?

    My main box is my Q9650 humping along at a tad under 4100, been running it at that for a long time, probably be another year before I change it out. Larry
  11. B

    OCZ Z Series 1Kw or Seasonic X750?

    I'm running the XFX 850W here,no problems at all with it, plenty of power and rock steady voltages. Larry
  12. B

    Win7: Black screen with only cursor at login.

    My setup has done this twice, still trying to figure it out here as well, running Win 7 64 bit here. I run an admin account as well as my normal Login and when it happened my only option was a reset. I did notice this happened on a Wednesday morning after updates from windows on a Tuesday. Larry
  13. B

    Computer + Water = FAIL... Advice?

    Well, I would have pulled the cpu first before powering up the board but is a mute issue at this point. I do think you should pull the cpu tho, check for scorching etc. Also without a video card installed I am pretty sure there is no boot. If this were me, I would strip the board of all...
  14. B

    Overclock passes 8 hrs P95 @ priority 10, but fails 1min of LinX?[SOLVED]

    It could be quite a few things including voltage for the NB, as well as maybe try a different version of OCCT. If memory serves, P95 needs a tad More voltage to run than OCCT, sometimes OCCT will act that way due to that slight bit Too much voltage that P95 needed to be stable. In my testing...
  15. B

    Buying SCSI HDs

    Those drives you linked too will work fine. As the controller will handle your 36 gig Fujitsu's it should handle any U320 80 pin drives. You may want to check around the for sale forums, etc as probably like myself, quite a few folks have drives laying around that would be cheaper than the one...
  16. B

    GTX 285 and a new monitor

    I have a 23" LCD, 1920 x 1080 and am running a GTX 280. Not too much gaming lately, COD4 and the like but the 280 runs that fine. Also waiting here until the bugs are out to upgrade to SB and then I will pick up a GTX 570 more than likely.IMHO, I personally would buy the monitor now on sale even...
  17. B

    ssd in a quad core setup on a asus p5q deluxe

    Your welcome. I'm sure you'll enjoy the heck out of it, glad I could be of help. Larry
  18. B

    ssd in a quad core setup on a asus p5q deluxe

    The P5Q-D I have runs the ssd fine, see components in my sig. I used to run a couple 15k scsi drives in RAID 0 before trying the ssd out, the ssd is a bit faster than the scsi setup was with less heat and power usage. Wouldn't do without and ssd again for a boot drive. Larry
  19. B

    XFX 850w vs Corsair AX850 vs Seasonic X 850

    I have the XFX Black Edition 850W, runs my setup fine, Excellent volotage output and I have yet to hear the supply at all. I wouldn't trust reviews off Newegg at all. JG has a good review on it. Only downfall as it were is that the cables are a bit stiff on it but that doesn't matter much. Larry
  20. B

    What is a good PSU for ~$175 these days?

    Quote "700W - 1000W Enermax Revolution 85+ ERV1250EGT 1250W - 104A from 6 +12v rails Enermax Revolution 85+ ERV1050EWT 1050W - 87A from 6 +12v rails OCZ Z Series 1000W - 83A on a single +12V rail Corsair TX 950W - 78A on a single +12V rail PC Power & Cooling Silencer 910W - 74A on a...
  21. B

    OCZ Vertex 2 failed after 4 weeks. :( Help!

    Try the Win7 repair a couple more times and see if it works. Had to do that once with the Beta, not sure if it will work with the retail/oem versions. Have you got a recovery disc for Win7? If so I "think" you can do a fixmbr or a fixboot with it. Sorry I can't be of more help as I have not...
  22. B

    NEC EA231WMi - Wow, what a high-class display!

    I have the EA231WMI and like it alot, been running it about 9 months I guess, no issues at all. Larry
  23. B

    MSI P35 Neo-F - worth saving?

    Nice board, as I remember a very stable board. I have a DFI NF3 Ultra-D that I just retired awhile ago, seems like the older boards were made very well. Larry
  24. B

    help overclcocking on my asus p5q deluxe

    The ram voltage on the deluxe runs .1v or more Higher than what is set in bios, for instance my ram is spec at 2.1v and 2.0v is right for the bios setting. To narrow the clock down on this board you need to play with the NB voltage, FSB Term voltage, Clock Twister and Performance level. PL is a...
  25. B

    Which to upgrade? CPU or GPU?

    IMHO, if your not severely bottle necked with the games you play now, I'd stick with what you have for now. If you think you Really need to upgrade I would save up a bit more and switch from 775 platform to SB, but again IMHO, I would wait until the new platform is a bit more mature and let the...
  26. B

    Broken Computer--please help! (No POST; only beeps with RAM removed)

    Last ditch effort for me without other hardware to swap in would be a cmos reset and battery out overnite. Larry
  27. B

    Broken Computer--please help! (No POST; only beeps with RAM removed)

    I think I'd try reseating all components first and check all wire connections. It would also help you a bit to post up what the computer consists of, ie PSU, Mobo etc. Larry
  28. B

    Ever just not want to get off your current platform

    :) I picked it up from another party here on the FS/Forum,too funny. I kinda thought it was you as at Xtreme I searched for the stepping and your posts over there popped up. I have her running at 9 x 454 @ 1.34v here and am sure she will go higher with the appropriate voltage. Temps with IBT...
  29. B

    Ever just not want to get off your current platform

    I'm still on a 775 system and still love it, as a matter of fact OP I think I have the other Q9650 you had, not a bad chip. I am waiting til fall or so to change platforms here. Larry
  30. B

    E8500 @ 3.8GHz Problems.

    Try upping the NB volatge a notch and try your game then. Quite often when you run Prime it does Not stress the NB as much as when in a game, also it seems you are on the brink with the OC, even tho it passes Prime it could falter in intense stress which is why I always stress test 1 fsb Over...
  31. B

    Prime95 question

    I run Blend at first and once that is stable I run a few other apps just to make sure I am good to go. Blend puts stress on the chipset, memory and cpu. IMHO it is best to run Blend. Larry
  32. B

    any OWC users sent for RMA?

    Does not sound like a positive expierience at all, sorry to hear that. Larry
  33. B

    Motherboard at 48 Degrees Celsius?

    Perhaps when you installed the side intake you moved your airflow, which could be pushing more of the hot air over the Temp sensor on the Mobo.I would try turning the side air intake off briefly and check your temps again. If thats the case, maybe you need more exhaust for the case. Larry
  34. B

    any OWC users sent for RMA?

    Other World Computing. Never had an RMA yet but could you elaborate? BTW they are located about 6 miles from my house. Larry
  35. B

    Motherboard Recommendations

    I've run the P4P800E-D myself before, nice stable board.I am running an Asus P5Q-D right now, actually have been for about 3 years I guess, never a glitch at all, I would expect you to get recomendations to quite a few brands here, however what I have used in the past is; MSI, a fair board but...
  36. B

    Windows 7 boot error

    Sounds like it could be either ram or a HDD going south. Perhaps try Memtest for a few full runs before you boot to windows. Larry
  37. B

    Corsair AX850 v. HX850, and a wild card

    I have the XFX 850 PSU, replaced a PCPower & Cooling 1KW with it, Quiet Beter voltage regulation and did I mention Quiet? :) I love it. I read up quite a bit at J.G. before making the decision of which to run, glad I got the XFX. Larry
  38. B

    XFX 850w Black Edition @ Newegg - $112 after rebate

    I run this supply, quiet and no problems here. Nice price too. Larry
  39. B

    Need DATA1.MSI (Office 2k Premium) anyone have it?

    Email coming right up! Larry
  40. B

    e * G.SKILL Phoenix Pro 240 GB SSD @ techPowerUp

    Thanks for the link. Always liked G.Skill memory so not too surprising that thier ssd's are good too. Larry
COMPANY
RESOURCES
FOLLOW
Top Bottom
sale-70-410-exam    | Exam-200-125-pdf    | we-sale-70-410-exam    | hot-sale-70-410-exam    | Latest-exam-700-603-Dumps    | Dumps-98-363-exams-date    | Certs-200-125-date    | Dumps-300-075-exams-date    | hot-sale-book-C8010-726-book    | Hot-Sale-200-310-Exam    | Exam-Description-200-310-dumps?    | hot-sale-book-200-125-book    | Latest-Updated-300-209-Exam    | Dumps-210-260-exams-date    | Download-200-125-Exam-PDF    | Exam-Description-300-101-dumps    | Certs-300-101-date    | Hot-Sale-300-075-Exam    | Latest-exam-200-125-Dumps    | Exam-Description-200-125-dumps    | Latest-Updated-300-075-Exam    | hot-sale-book-210-260-book    | Dumps-200-901-exams-date    | Certs-200-901-date    | Latest-exam-1Z0-062-Dumps    | Hot-Sale-1Z0-062-Exam    | Certs-CSSLP-date    | 100%-Pass-70-383-Exams    | Latest-JN0-360-real-exam-questions    | 100%-Pass-4A0-100-Real-Exam-Questions    | Dumps-300-135-exams-date    | Passed-200-105-Tech-Exams    | Latest-Updated-200-310-Exam    | Download-300-070-Exam-PDF    | Hot-Sale-JN0-360-Exam    | 100%-Pass-JN0-360-Exams    | 100%-Pass-JN0-360-Real-Exam-Questions    | Dumps-JN0-360-exams-date    | Exam-Description-1Z0-876-dumps    | Latest-exam-1Z0-876-Dumps    | Dumps-HPE0-Y53-exams-date    | 2017-Latest-HPE0-Y53-Exam    | 100%-Pass-HPE0-Y53-Real-Exam-Questions    | Pass-4A0-100-Exam    | Latest-4A0-100-Questions    | Dumps-98-365-exams-date    | 2017-Latest-98-365-Exam    | 100%-Pass-VCS-254-Exams    | 2017-Latest-VCS-273-Exam    | Dumps-200-355-exams-date    | 2017-Latest-300-320-Exam    | Pass-300-101-Exam    | 100%-Pass-300-115-Exams    |
http://www.portvapes.co.uk/    | http://www.portvapes.co.uk/    |