Search results

  1. PSU died, then came back alive an hour later.

    If it where me, I would install the new psu and check into getting an rma for the Evga. Most likely it will fail again. Just explain what happened and how you tested it to conclude the psu was at fault.

  2. XMP profile help? Stuck to DDR3-1600

    I have some Gskill 1866 also that did the same thing. I set it to xmp and all it showed was 1600. I left it set at xmp and "saved" the bios setting. Rebooted and went back into the bios and 1866 was there. Sometimes a simple save and reboot works. .

  3. AMD set to slash FX CPU pricing on September 1

    They might lol worth a shot LOL

  4. AMD set to slash FX CPU pricing on September 1

    Well I will just say that it does say on my retail tin that my 8350 came in " Unlocked and Overclockable " As long as you don't go all crazy with the overclock and use proper cooling they will warranty it. Pushing a 8350 to 4.7 with the stock HSF is a example of going crazy and a big no no that...

  5. AMD set to slash FX CPU pricing on September 1

    My one Linux Rig Even if you just bumped the 8320 up to 4.0 it helps out alot. Just make sure you have a decent board as the vrms can get warm quick without good cooling. I actually put a small fan to blow on the heatsink on my vrm section of the mobos just to be safe.

  6. AMD set to slash FX CPU pricing on September 1

    Yeah running @ 4.4 just like my 8320. Both are under water so the run right about 40c under full load Wcg is the ultimate stability tester LOL. 100% load 24/7/365. Oh and here is the 1090t LOL

  7. AMD set to slash FX CPU pricing on September 1

    Oh I know buddy. 2 of the rigs have to stay under Windows as 1 is my main rig (8350) which I game on also and the other (Phenom II x6) is the backup for that rig. But the 8320 and 8150 can go to Ubuntu as they are along with the 920 dedicated crunchers. They where built for that purpose only and...

  8. AMD Readies FX-8370, FX-8370E Microprocessors.

    I think the 8370e will appeal to the lower end and older broads that had/have a weak vrm circuit. This alone can make for a great low buck setup.

  9. AMD set to slash FX CPU pricing on September 1

    I am going to side with the statements made by MiddleOfTheRoad in regards of the Fx and Wcg. I run a Wcg on 5 Rigs. 3 are Fx based (8350 @ 4.4, 8320 @ 4.4 and a 8150 stock) 1 Phenom II x6 1090t at 3.5 and a i7 920 at 3.5. The Fx 83xx's are of course pretty close in ppd. The 8150 and the Phenom...

  10. i7 4790 vs fx-8350

    I have 3 fx rigs and all 3 are under win7. All perform great. My main rig has a 8350 clocked at 4.4. It runs 100% load 24/7/365 (crunches) with no issues and I do all my daily task without and slowdowns. I also game and the thing takes whatever I throw at it with ease. So op chose whatever fits...

  11. Windows 95 OEM

    Hey Shadowknight, what are the rest of the specs of your retro rig? I built myslef one a fe months ago. I used a MSi 6167 Slot A board with a 800 Mhz Athlon proc, 128 mb of pc133, Rage Fury pro gpu, and a Aureal A3D Vortex 2 SQ2500 soundcard. All running under win 98se.

  12. [DEAD] - Seagate 600 240GB SSD $209.99 w/ FREE 2TB HDD!

    Currently sold out

  13. Just got a Phenom II 1100T - OC'ing Advice?

    I have my 1090t at 3.6 on stock volts and it runs about 43c under full load.

  14. Do tower heatsinks put stress on the motherboard?

    All 7 of my rigs have tower heat sinks on them and 6 of them are Cm Hyper 212+'s. I have never once had a problem.

  15. Focusing on World Community Grid

    You can set it to only use the gpu when the system is idle under the advance/preferance tab. Right at 4 mins and crunching 2 units at a time with my Cfed 6850's. These thing will generate some serious points. I have already done close to 90 of them this evening at 50 points a pop. Now the...

  16. Anyone own Alice: Madness Returns?

    :thumbsup: no problem man. I also have the original and have owned it since it came out.

  17. AMD marketing Steamroller before Vishera launch. Thoughts?

    All I have to say is you'll better hope they stay making cpu's and gpu's. I don't think want to be down to one company each making those. They will be able to charge rediculus prices for them because they will have no competition.

  18. Tools

    And to this list I would add the XXL Gear Wrench ratcheting wrenches. You just do realize the value of the extra length until you use them. A nice set of air tools if you are planning to do alot of work on your car. These can be real time savers. I would also add a good quality multi meter and...

  19. Front strut is leaking

    Well quoted. At dealerships the way it works is that they total the number of hours billed for that week then divide that total between the number of tech's. So if there where 100 hours billed to customers that week and 4 techs then each one would end up getting paid for 25 hrs that week...

  20. Front strut is leaking

    Okay the op take his car to a dealership to have the oil changed. And they find a leaking strut but he can't see what they are talking about. Do you think he would have the ability to do the job? If he did he wouldn't have been asking about the prices the dealer where going to charge. would you...

  21. Front strut is leaking

    I agree a person that has the ability and and understanding can certainly do this job himself they just need to use extreme caution while doing it. I would never down a home mechanic or there abilities to work on there car. But someone that doesn't work on there own car this may not be the task...

  22. Front strut is leaking

    And thank-you HarryLui, I was looking for a vid just like that to prove my point. Now they should have showed where the strut body went because it went to other direction and what did it hit? Also read the comments.

  23. Front strut is leaking

    Thank-you SparkyJJo. That is the point I have been trying to make. These thing if you don't know what you are doing or lack the ability to do it can hurt you. And there is nothing wrong with not having mechanical ability.

  24. Front strut is leaking

    No that is not what I said at all. If you would have been reading my post you would know that. You assume to much. I said there should be great caution when replacing your own struts. You are putting words into my mouth that I didn't say. Also there are 2 people in here saying you don't need a...

  25. Anyone own Alice: Madness Returns?

    I have a link for a copy on ebay of the pc version of the Original game for $8.98 shipped if you want it.

  26. Front strut is leaking

    Let that spring slip or not be clamped down correctly and see what happens. That thing is under thousands of pounds of force. It can shoot the strut body through a wall or you. So yes you can die. As to why there are safety devices on strut spring compressors and most of the good compressors...

  27. Front strut is leaking

    Umm it not that easy bud. Struts are totally different then coil springs. The strut maintains it's tension after the load of the car is removed. I highlighted it in red so the op would know that there is danger in trying this without know what's involved in this. Obviously you haven't changed a...

  28. Clunking during shifting

    Now feeling it in all gears which I was under the impression it wasn't is a sign of a clutch not disengaging fully.

  29. Front strut is leaking

    Actually I did forget about loaded struts. Yes he can use those if it isn't to cost prohibitive for him. Some loaded struts can be pricey.

  30. Clunking during shifting

    Now I take it that you don't hear/feel it going into any other gear especially reverse right? If it was a clutch issue like the clutch not disengaging all the way you would have a harder time going into reverse with more noise then first.

  31. Selling car to Carmax

    Also they will want to make a profit on the car so the offer will be well below Kelly blue book on it. But it is not going to hurt anything for you to take it in to see what they do offer you for it. You can always decline the offer. And you have to KBB value of the car so you know what the car...

  32. Clunking during shifting

    I am going to go a different route as I don't think it is the flywheel by what you said in your op. I am going to go with either a worn synchro or possibly a shift fork being wore. How many miles are on the car? Also why I say this is that you stated it makes the clunking while you are putting...

  33. Lawn mower trouble

    The 10% Ethanol fuel is know to gum carbs on small engines. So you probably are going to have to either rebuild or replace the carb and then try and use Ethanol free gas in your small engine. Actually it will also wreck havoc in carbs for cars also.

  34. Front strut is leaking

    That's right "if he is mechanically inclined" and knows how to properly use the tool. I take it as he is not due to the fact of the questions he asked. I have no objection to people repairing there own cars and such, hell I actually encourage people to try and learn to do it. But there are...

  35. The unofficial *nix screenshot thread!

    Hey VinDSL, where would one get your conky script?

  36. Lawn mower trouble

    What gas are you using? Standard pump gas with 10% etenol? My money is that the carb is gummed up inside.

  37. Front strut is leaking

    If they are leaking then yes they need to be replace. Call around and get other estimates on the job. And by no means attempt to do this yourself. The springs are under tremendous pressure, removing the center nut without the spring clamp down and compressed can kill you and anyone around you...

  38. The unofficial *nix screenshot thread!

    Ubnutu 12.04 w/ Cinnamon

  39. Can i use my old power cable for the PSU?

    You will be fine.

  40. AMD marketing Steamroller before Vishera launch. Thoughts?

    In before it gets real stupid.
COMPANY
RESOURCES
FOLLOW
Top Bottom
sale-70-410-exam    | Exam-200-125-pdf    | we-sale-70-410-exam    | hot-sale-70-410-exam    | Latest-exam-700-603-Dumps    | Dumps-98-363-exams-date    | Certs-200-125-date    | Dumps-300-075-exams-date    | hot-sale-book-C8010-726-book    | Hot-Sale-200-310-Exam    | Exam-Description-200-310-dumps?    | hot-sale-book-200-125-book    | Latest-Updated-300-209-Exam    | Dumps-210-260-exams-date    | Download-200-125-Exam-PDF    | Exam-Description-300-101-dumps    | Certs-300-101-date    | Hot-Sale-300-075-Exam    | Latest-exam-200-125-Dumps    | Exam-Description-200-125-dumps    | Latest-Updated-300-075-Exam    | hot-sale-book-210-260-book    | Dumps-200-901-exams-date    | Certs-200-901-date    | Latest-exam-1Z0-062-Dumps    | Hot-Sale-1Z0-062-Exam    | Certs-CSSLP-date    | 100%-Pass-70-383-Exams    | Latest-JN0-360-real-exam-questions    | 100%-Pass-4A0-100-Real-Exam-Questions    | Dumps-300-135-exams-date    | Passed-200-105-Tech-Exams    | Latest-Updated-200-310-Exam    | Download-300-070-Exam-PDF    | Hot-Sale-JN0-360-Exam    | 100%-Pass-JN0-360-Exams    | 100%-Pass-JN0-360-Real-Exam-Questions    | Dumps-JN0-360-exams-date    | Exam-Description-1Z0-876-dumps    | Latest-exam-1Z0-876-Dumps    | Dumps-HPE0-Y53-exams-date    | 2017-Latest-HPE0-Y53-Exam    | 100%-Pass-HPE0-Y53-Real-Exam-Questions    | Pass-4A0-100-Exam    | Latest-4A0-100-Questions    | Dumps-98-365-exams-date    | 2017-Latest-98-365-Exam    | 100%-Pass-VCS-254-Exams    | 2017-Latest-VCS-273-Exam    | Dumps-200-355-exams-date    | 2017-Latest-300-320-Exam    | Pass-300-101-Exam    | 100%-Pass-300-115-Exams    |
http://www.portvapes.co.uk/    | http://www.portvapes.co.uk/    |