Search results

R
AMD RYZEN 2000 Builders Thread

At stock many board will overvolt, it seems to top at 1,55V for the short XFR bursts. I have my 2700X under a Kraken X62 at maximum PBO, auto mp and a set 1,45V. It wil run almost anything at 4,3GHz all core en frequently boosts to 4,35GHz in lighter loads(even when it is all core). OCCT runs at...
- Razkin
- Post #276
- Jun 1, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

Yes, manual settings. On the Gigabyte you can set the precision boost overdrive to enabled and select a voltage overdrive scalar from 1 to 10. In my case 8x gave too much and all core mp was lower than using 7x, upping the base clock to 102MHz, gives me my core speeds. Doing it this way will...
- Razkin
- Post #141
- Apr 26, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

That's seems like a decent sample. I am also running Prime95 small FFT at around the same core speeds, I did have to tweak the cpu to get the same core clocks. But currently around 90minutes in gives the following Hwinfo stats: https://imgur.com/a/rvTdYCM It needs 0,15V more and the power...
- Razkin
- Post #139
- Apr 26, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

I meant Wraith Prism as I have a 2700X. My setup has been in the open with around 20C ambient. https://imgur.com/a/cTMvZO2 I am awaiting my Kraken X62 bracket from NZXT to properly cool it and eventually cool it with the custom loop that is now sitting on my 4790k setup. For now I am just...
- Razkin
- Post #127
- Apr 25, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

Running a Gigabyte X470 Gaming 7 Wifi and 16GB FlareX 3200MHz C14. With the Spire I have tried every setting to get it to run at levels as found in the reviews, as in 4GHz all core clocks, but the cpu can not maintain 4GHz. Running Heaven or the FFXV benchmark ends up somewhere between 3925 and...
- Razkin
- Post #125
- Apr 25, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

I have a 2700X. Cinebench will run ~3900MHz OCCT will run ~3800MHz IBT even brings it down to 3,7GHz baseclock. It needs at least 1,375V to run 4GHz, less will crash have not stablity tested so could end up worse. 4,2GHz needs 1,4475, lower will crash not tried stability.
- Razkin
- Post #122
- Apr 25, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

It depends if you have a good sample or a bad one. Mine is bad, it will only run full core load @3,8GHz with ~1.325V. This is with everything set to stock, the Spire will let the cpu run @80C while the fan spins @3000rpm and that makes a lot of noise. Better cpu's will run all core loads at...
- Razkin
- Post #119
- Apr 25, 2018
- Forum: CPUs and Overclocking
R
AMD RYZEN 2000 Builders Thread

My first one looked like https://imgur.com/a/IAT9uGr The store was willing to let me exchange the cooler including the cpu, the second cooler isn't any better and the second CPU performs terrible. Does only run full load @3,8 ~ 3,9GHz with 1,325vcore.
- Razkin
- Post #94
- Apr 23, 2018
- Forum: CPUs and Overclocking

RESOURCES

Top Bottom