Got a new psu. Its working fine, the old one was faulty.
The Ryzen 3500 was released in the Indian market as a retail unit. Now it has been replaced with the 3500x.
From past few months I have started to face a lot of issue with my pc.
It all started with my mouse led flickering when there is a power fluctuation.
From there it went to issue with UPS No. 1 (further referred as microtek) which I changed to APC but it exhibited more or less the same issue...
Guys it was a dud ups. The next day i took it in for servicing and they replaced the control circuit.
I got back home and put it on charge and its circuit board caught fire.
Looks like UPSes are redacted now. Just 11 months of usage and it decides to poop itself.
Profanity is not allowed in the tech forums.
AT Mod Usandthem
Hello,
I am facing some issue with my UPS and PSU. Need some help here.
Case 1:
Whenever I do high load tasks like gaming and power cuts off my UPS goes into backup mode but my PC shuts down. Now when I try to power on the PC it doesn't respond which means PSU Protection Circuit was...
My AIO fan has started to make a faint rattle/grinding like sound when it runs at full speed.
If I press on the hub or lower the speed to ~1500rpm it goes away.
Is this a typical case of bad bearing? The aio is practically not even 6months old. Bought it in end of may 2020.
Any solutions to...
So it is a standoff issue. All my case standoffs are pre-installed or rather welded to the case. So I need to run the gpu like this only.
But as others said its not an issue as 95% of it is inside the slot, if it were to short out it would have done so on the first boot.
Tried to loosen screws and shift the motherboard towards the I/O, didnt work. Maybe case standoff position is a bit off and asrock having smaller holes gives issues and the standoffs dont line up properly. I tried pushing the mobo towards the I/O but that didnt work and the screws go out of...
The circled part of the gpu is not going in all the way and is staying out by approx a mm. So I have to bend in the cabinet mounts to screw it in place properly.
I changed my motherboard to an atx x570 today from an atx x370. The gpu went in all the way in the x370.
Is it because of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.