Hi,
I installed the Intel Application Accelerator v2.0 on my new P4 system, but after installation only the boot HD (SCSI U160) starts to spin when the system resumes from standby. The two other disks (attached to the ordinary IDE controller) won't resume. I use an ABIT BD7-Raid MB. I have...
Hi
Ihave a couple of registered DDR modules with ECC, and I would like to reuse them in my new setup. Soyo SY-K7V Dragon+ seems like a good motherboard choice, and I know it has support for ECC, but can it also handle registered modules?
TIA,
senzan
Hi,
I have an Abit KG7-R which runs pretty troublefree with two 256 MB DDR-modules from Twinmos. The modules are registered and support ECC. I may need more memory, but since I am planning to buy a P4 and an i845-D based motherboard the next time I upgrade (i.e., a board based on the DDR...
Hi
I have a 256 MB DDR memory module (ECC + registered) from TwinMos. The shop where I ordered it said CL 2.5, but the sticker on the module says CL 2. And the TwinMos home page says "CAS latency 2,2.5 (clock)", as you can see here. So which CL setting should I use in the BIOS? I have tried...
Not all motherboards support ECC memory. This is due to limitations in the chipset, I suppose. But what about those that support ECC, will they necessarily accept registered modules as well?
Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.