I have 2 questions. I am setting up my DFI DR and wonder what the difference between the regular SATA and Silicon SATA controllers are. Also, what is the difference between LAN 1 and LAN 2. Why would you choose one over the other? Thank you.
I have a BD7 raid mobo and have raid 1 installed. Each time I startup I get the message "did not finish rebuild" I enter raid bios and rebuild - all is ok. I use my computer - works ok - then shutdown, and when I start up I get the same problem. Happens everytime after a warm reboot and a...
Put in a PCI video card -- no luck. Then I disconnected everything - still get same error code. One long, long beep at the beginning. Should I take the board out of the case and try it?
The case is new, an Antec sx635. I have new 256MB Micron DDR memory. I have one HD - Western Digital 102AA - 10 GB. I have an AGP Nvidia GeForce2MX200 Video card. I have a new Pentium4 1.6 Northwood. I have one floppy. I have a 56X cdrom. I installed the standoffs matching up the holes on...
I just installed a new Abit BD7 motherboard and it will not boot. The Post Code LED says A7, but I can't find that code in the manual. Anyone know what the code means?
I just installed a new Abit BD7 motherboard and it will not boot. The Post LED shows a code of A7. I can't find that code in the manual. Can anyone help?
Quick question -- I just got my 1.6a and am ready to install it. I noticed a small hole on the top of the processor and wonder if I have to do anything special when I apply the thermal paste. I am using a Swiftech heatsink instead of the stock one.
---- Bill
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.