ABiT kt7-raid, only running at AGP 2x..

[aventari]

in WCPUID it shows my kt7 only at AGP 2x.. I have a inno3d geForce2 MX

I set 4x enabled in the BIOS but it's not working. I have the latest 4n1 drivers and AGP drivers installed too.
Any suggestions?

thanks!

aventari

 

[Marauder]

From Tomshardware:




<< Loading the BIOS with &quot;Optimized Defaults&quot; causes a peculiar AGP mode setting. In this case AGP only runs in 2x mode. This does not affect the general functionality but the graphics performance may suffer a little. >>



Try and change the setting it migth just do the trick - good luck!!

 

[springdale]

check out this article from tweaktown.com:

http://www.tweaktown.com/articles/via_agp4x/

&quot;If you have a motherboard based on the VIA Apollo 133A, KX133 or KT133 you may find sometimes (not in all cases) that you can't get your graphics card to run at AGP 4x within Windows 2000, especially when using NVIDIA reference drivers. With these drivers the registry setting for AGP 4x on VIA Apollo 133A, KX133 or KT133 chipsets isn't enabled.

Update: Due to an excess amount of TweakTown users asking how to do this same registry hack in Windows 9x we have updated this guide and included the registry hack for Windows 95, 98, 98se and ME.&quot;

Hope this helps.

 

[aventari]

thanks a lot! the registry fix worked great, and it's running in 4x mode. Of course i dont notice a difference, but it's nice piece of mind

aventari

 

[aventari]

thanks a lot! the registry fix worked great, and it's running in 4x mode. Of course i dont notice a difference, but it's nice piece of mind

aventari