Originally posted by: Dynomike
Can anyone help me overclock on my ASRock 4CoreDual SATA2? I have:
Pentium D 930 (3.0Ghz Dual Core with 800Mhz FSB)
Wintec DDR2 533Mhz (PC-4200) Dual Channal RAM (4 Cas Latency)
ATI Radeon X1650 512Mb 128-bit AGP 8x IceQ (24 Pixel Pipelines)
Apevia 500W Power Supply (2x120mm fans)
Two Apevia Case Fans
60 gig ATA 133 IBM HD
15 gig ATA 133 Maxtor HD
My computer generally runs at 34C (93F)
If any other specs are needed let me know. I cannot figure out how to over clock on this mobo.It says it has some United Overclocking Ability. Not idea what that is but I just need anyhelp with overclocking in the bios. I still have the stock bios version. I didn't want to mess with anthing till I get some instructions. Any tip or whatever would be great.
You could try these settings for an overclock to 3.75ghz which should be fine with the stock heatsink and stock voltage and 2 sticks of your ram. :
1st, clear your CMOS and load optimized defaults, then make these settings.
Asrock 4CoreDual-SATA2 Bios Version 1.80
CPU Configuration
==================================================
CPU Host Frequency [Manual]
Actual Frequency (MHz) [250]
PCIE Clock [100 MHz]
AGP/PCI Clock [66/33 MHz]
Spread Spectrum [Disabled]
Boot Failure Guard [Enabled]
Ratio Acutal Value 15
Max CPUID Value Limit [Disabled]
No-Execute Memory Protection [Disabled]
Chipset Configuration
==================================================
DRAM Frequency [266MHz (DDRII533) ]
Flexibility Option [Disabled]
DRAM CAS# Latency [4]
DRAM Bank Interleave [4-Way]
Precharge to Active (Trp) [4T]
Active to Precharge (Tras) [12T]
Active to CMD (Trcd) [4T]
REF to ACT/REF to REF (Trfc) [28T]
ACT (0) to ACT (1) (Trrd) [2T]
Read to Precharge (Trtp) [Auto]
Write to Read CMD (Twtr) [2T]
Write Recovery Time (Twr) [4T]
DRAM Bus Selection [Dual Channel]
DRAM Command Rate [2T Command]
> Advanced Memory Configuration [Untouched]
> Advanced Host Configuration [Untouched] Except for Pipeline DRQCTL Enabled
DRAM Voltage [Auto]
AGP Voltage [High]
Primary Graphics Adaptor [AGP]
AGP Mode [8x]
AGP Fast Write [Enabled]
AGP Aperture Size [256MB]
AGP Staggered Delay [Auto]
AGP GADSTB Output Delay [Auto]
AGP 3.0 Calibration [Enabled]
AGP 3.0 DBI Function [Auto]
DBI Output for AGP Trans. [Enabled]
DBI Output for FRAME Trans. [Auto]
V-Link Speed [Normal]
V-Link disable [Enabled]
PCI Delay Transaction [Enabled]
IDE Drive Strength [Normal]
PCIE Downstream Pipeline [Auto]
OnBoard LAN [Disabled] * If you want use, then Enabled
OnBoard HD Audio [Enabled]
Front Panel [Disabled]
CD-In [Disabled]
Echo TPR Disable [Auto]
Save and reboot.