sandeep108
Senior member
- May 24, 2005
- 220
- 0
- 0
Originally posted by: intersys
The 1009 BIOS is out as beta - has anyone tried it?
I think I will hold off updating to 1008 from 1006 for now.
Originally posted by: intersys
The 1009 BIOS is out as beta - has anyone tried it?
Originally posted by: DMarti
ok Mobo arrived (REV 2.0) and the NB Fan is not so bad. I booted right into post and then I booted into Windows. Flawless no issues whatsoever
Originally posted by: plion
Just got a quick question, I set my voltage manually to 1.35 but in cpuz it's listed as 1.344 is this normal?
Originally posted by: sandeep108
PPPP: This is a known issue when installing xp. Ensure that your IDE is physically disconnected at the time of xp install. Then the SATA will get C, CD ROM D and the IDE slave E, F... and boot should proceed as normal. You can try to change the drive letters through disk management but I am not too sure that it will help. You may need to re-install xp. I would also suggest updating to the latest bios.
Originally posted by: sandeep108
Spiffae: From the A8N-E manual, some types of double sided sticks may not work in dual channel config due to CPU limitations. If one stick only, you have to use slot B1. But by and large most newer sticks should work in dual channel. Your CPU?
Originally posted by: Spiffae
Originally posted by: sandeep108
Spiffae: From the A8N-E manual, some types of double sided sticks may not work in dual channel config due to CPU limitations. If one stick only, you have to use slot B1. But by and large most newer sticks should work in dual channel. Your CPU?
The sticks are new, I'm runing a San Diego 3700+
Originally posted by: hezzy
Ok heres my problem.
I have tried 3 differant power supplies,
2 differant graphics cards
differant memory
in the case and outside the case but nothing will get this board to boot or give any video signal.
Everything is new out the box.
Any ideas ?
Thanks
hezzy
A8N-E
64 3000 venice
geforce 6600gt
q-tec 550w psu
geil 512mb dual channel x2
Originally posted by: hezzy
Thanks for the reply
After trawling many forums, I am beginning to suspect the psu. The Q-Tec is cheap and cheerful but only has the 20 pin atx connector. I got a 20 to 24 adapter but still no go.
I've left the offending item in local pc store to try a few diagnostics but I think I'll be purchasing a better quality psu with proper atx 2 specs. Tagan, Enermax,Ocz and Antec spring to mind..
Any recommendations welcome
Cheers
Hezzy