Originally posted by: Stoneburner
I got mine yesterday. Haven't tried it but it was packaged in a very stupid mannner, just had some plastic shroud and was dropped in a box without being secured in any position.
Originally posted by: jjmIII
My two are just sitting there "Initiated" since the 17th. I'm real excited to get them after all the bad packing news :disgust:.
Originally posted by: tomatom
* http://www.monoprice.com/produ...id=1321&seq=1&format=2
Fixes the 4 pin power connector problem if the 8 doesnt split. *
... maybe Yes , maybe No , be sure not to have everything connected
to just ONE 12V rail ...
Originally posted by: nyker96
E4300: check this out http://forums.hexus.net/abit-c...intel-e0-stepping.html
it's a beta bios supposedly supports e0, might work for r0 as well.
Originally posted by: E4300
Originally posted by: nyker96
E4300: check this out http://forums.hexus.net/abit-c...intel-e0-stepping.html
it's a beta bios supposedly supports e0, might work for r0 as well.
Thanks. I used that BIOS but it will only POST with "M1" Q8200. No go with the newer "R0" chip. No problem hitting 485MHz with M1 Q8200.
Originally posted by: jjmIII
My two are just sitting there "Initiated" since the 17th. I'm real excited to get them after all the bad packing news :disgust:.
Originally posted by: nyker96
Originally posted by: E4300
Originally posted by: nyker96
E4300: check this out http://forums.hexus.net/abit-c...intel-e0-stepping.html
it's a beta bios supposedly supports e0, might work for r0 as well.
Thanks. I used that BIOS but it will only POST with "M1" Q8200. No go with the newer "R0" chip. No problem hitting 485MHz with M1 Q8200.
that's too bad, we ip35e owners need to find someone who can modify official bios to suite the new cpus, doesn't look like abit will do it.
Originally posted by: nyker96
my other rig has a 92mm ac freezer pro, at full load even in a p182 case i can hear it loud and clear, i doubt your Quattro 850W gets to that level.
Finally, there is the single Adda 80MM fan in the rear. The AD0812UB-A70GL is an 80x25mm ball bearing fan capable of moving 43.8 CFM at 3400 RPM.
Originally posted by: JDMnAR1
Mine were delivered yesterday, and I must say that the packaging job was just fine. The outer box (20x20x10) was in perfect shape, and the PSUs were boxed inside that, with each individual box filled with foam padding. Since the outer box was significantly larger than the two inner boxes, it was filled with air pillows.
My PSUs have non-split 24pin/8pin connectors, but in looking at Enhance's site, there are different revisions of this PSU, some of which do have split connectors. Installed one in a box I have that the mobo actually has an 8pin connector and it seems to work just fine. It is actually even pretty quiet, which is a bonus.