Can't access Cisco Aironet web page

[nLinked]

We have a Cisco Aironet 1131AG access point and are trying to access its config page to change its hostname. Its IP address pings but the page says page not displayed. Any ideas?

We have a number of these in the company but all don't allow web config page access.

 

[spidey07]

Is it lightweight or not? If it is you do all management from the controller.

 

[Stargun]

What is the full model number on the back of the AP. There should be a sticker that has the model number, serial number and mac.

If it is AIR-LAP-* it is a lightweight AP and you can not configure it directly period.

If it is AIR-AP-* then it will be autonomous and you might have the web gui turned off and need to access the AP via a consul cable.

 

[Cooky]

Web GUI on those autonomous WAP's is very slow. (at least that was the case w/ 1230 & 1240, not sure about 1140's)
You're better off configuring it from CLI anyway.

Can you ssh or telnet into it?
If you really need GUI access, make sure "ip http server" is in the config.
Also need to make sure the actual web pages are still on the flash disk.
We remove them to make room to store the actual IOS.