My brother removed a 120mm fan from a 300W PS I had, and I am considering adding it to the side of my case. I cleaned it up and saved the screws and grille, but it also has two loose wires. I have a PS extender with a two pin extension on that (purchased 'em from 3dfxcool awhile back). I am going to sever the 2-pin extension and connect the wires from the fan to the extension (red to red, black to black) and then plug this contraption to my PS.
My question is this: Where should I put this fan?!
I have a slot cooler under my AGP card blowing air out from there, and I also have a fan below my PS blowing air out (I have an Elan Vital T10X case, FYI). I also have a front fan sucking air into the case. Should I add this fan over my expansion cards (SBLive! & Intel Ethernet card), or should I put it over my CPU, thus sucking the air from the CPU fan out? I have a generic fan, but have an Alpha PAL6035 on order.
Thanks!
Sedimin
PS. I plan to do this with a Dremel power tool and will file any burrs off the case (after drilling).
My question is this: Where should I put this fan?!
I have a slot cooler under my AGP card blowing air out from there, and I also have a fan below my PS blowing air out (I have an Elan Vital T10X case, FYI). I also have a front fan sucking air into the case. Should I add this fan over my expansion cards (SBLive! & Intel Ethernet card), or should I put it over my CPU, thus sucking the air from the CPU fan out? I have a generic fan, but have an Alpha PAL6035 on order.
Thanks!
Sedimin
PS. I plan to do this with a Dremel power tool and will file any burrs off the case (after drilling).