E4300 Overclocks?

[AAjax]

Originally posted by: Puffnstuff
Some of you guys should feel special. The highest my e6400 would go on stock vcore was 2.6. Anything past that wasn't completely stable. I'm currently at 338x8=2.7 with a vcore of 1.35 and although I've meddled just a little at 2.8 it was not stable even with a little voltage bump. I'm not trying to trash my setup so I backed down and that's where I'm staying. If you can crank her up with little or no vcore bump then you are among the lucky ones.

The secret to the 4300 is the 9x multiplier. Of course investing in a good MB and high end ram dosent hurt.

 

[wfp]

Got a E4300 this week and I am currently running it at 8x400 w/ 1.3v(in bios)/1.29 under load. I actually might be able to drop the voltage by another .1 or so.

Batch Q645.

 

[gorobei]

e4300 fry's oem special
ga965p ds3 r3.3 bios f10
corsair xms 2x1GB ddr2 800
noctua U12F

hits 3.0Ghz no problem 9x333 cpu 1.4v(could probably go lower) everything else stock volt
but will only go 3.15Ghz @ 9x350 cpu1.48v all other voltages maxed out. barely stable(northbridge gets too hot)

I've tried all kinds of lower multipliers and higher FSB but they wont even post.

 

[utfrodo54]

e4300 from the egg
ga965p ds3 1.3 f11 bios
g.skill F2-6400PHU1-1GBNR @ 4-4-4-12 (+.1v on the bios for 1.9v)
ocz 700w psu
saphire x1950 pro
antec p180
thermaltake hsf on northchip, stock cooling on cpu for now

9x266 = ~2.4ghz easy on stock cooling, stock cpu v, 44ish idle, 52 on load, dropping more and more as as5 cycles

havent tried any higher, no need to atm. key error i ever got was mobo not holding oc settings if memory wasnt at 2 (1:1)