- Sep 30, 2004
- 67
- 0
- 0
I'm trying to oc my e6600/P5B Dlx rig to 333fsb. All is fine at 300 and 320, but when I go up to 333 I start getting rounding errors when running Prime95 LARGE FFT test. The SMALL FFT test runs fine for hours with no errors.
Here are my settings...
FSB = 333
DRAM = 666
PCI = Locked @ 33.3
PCIE = Locked @ 100
Spectrum Spread = DISABLED
CPU Core V = Tried between 1.3 and 1.35
DRAM Timing = 5-5-5-15
Static Read Control = Tried both AUTO and DISABLED
Am I correct in assuming that since only the Large FFT test fails my issue probably lies with memory? My ram is Corsair Twin2X DDR 800 5-5-5 (2gb, 1gbx2) I've noticed that other here have been using SPECTRUM SPREAD set to AUTO. Should i try that?
Also, what about increasing the voltage to my VCore? I've only gone as high as 1.35 since my cpu tends to run a little hotter than the average 6600.
Thanks
Here are my settings...
FSB = 333
DRAM = 666
PCI = Locked @ 33.3
PCIE = Locked @ 100
Spectrum Spread = DISABLED
CPU Core V = Tried between 1.3 and 1.35
DRAM Timing = 5-5-5-15
Static Read Control = Tried both AUTO and DISABLED
Am I correct in assuming that since only the Large FFT test fails my issue probably lies with memory? My ram is Corsair Twin2X DDR 800 5-5-5 (2gb, 1gbx2) I've noticed that other here have been using SPECTRUM SPREAD set to AUTO. Should i try that?
Also, what about increasing the voltage to my VCore? I've only gone as high as 1.35 since my cpu tends to run a little hotter than the average 6600.
Thanks