I have an Enermax UC-A5FATR2 fan/temp controller. It has the capacity to monitor six fans and has two temp probes. The readout shows the two temps and two fan speeds.
I love how I can watch temps go up and down as I use the computer. I'm not really a control freak, just like to see what's happening. The problem I have is that you can program an alarm for the four readouts (2 temps & 2 fans), but when you turn the computer off, the programing reverts back to the defaults. The temp defaults are 45°C, which is OK for regular stuff, but when I overclock and run burn-in, etc the alarms go off. Also, with the warmer weather, the temps are a bit higher and the alarms have gone off a time or two with normal computing. Anybody have one of these and know how to get around this problem (other than leaving it on all the time)?
I love how I can watch temps go up and down as I use the computer. I'm not really a control freak, just like to see what's happening. The problem I have is that you can program an alarm for the four readouts (2 temps & 2 fans), but when you turn the computer off, the programing reverts back to the defaults. The temp defaults are 45°C, which is OK for regular stuff, but when I overclock and run burn-in, etc the alarms go off. Also, with the warmer weather, the temps are a bit higher and the alarms have gone off a time or two with normal computing. Anybody have one of these and know how to get around this problem (other than leaving it on all the time)?