Geforce 4 4400 fitting into Epox 8KHA+?

[BlueScreenVW]

I'm looking into buying either a Gainward 4400 or a Creative 4400. The Gainward should be compatible according to Epox's list, but the Creative isn't mentioned there, so I'd like to know if it fits for you? Furthermore, although the Leadtek cards should be OK according to Epox there are reports of them not fitting spread on the net. So, anyone has experience with the Gainward, Creative and Leadtek Geforce 4 cards?

 

[Mem]

I know someone that has the Gainward GF 4 TI 4600 on the Epox 8KHA+ board and it fits fine,if I was you I would stick with the recommended brands from Epox site for that board which are Gainward,Leadtek,MSI etc,there are probably more that will fit ok but you might as well get one you know will not cause any problems.

 

[gaidin123]

I know that it is not on Epox's recommended list but I ordered one of the Visiontek GF4 Ti4400s from the Gateway accessory store early on and it does fit on my Epox 8kha+ motherboard. There's very little clearance between a capacitor on the card and a capacitor on the motherboard but it does fit fine without any components touching.

Gaidin

 

[BlueScreenVW]

Thanks Mem and gaidin123 for the replies. Apparently the Visiontek cards (or tyhe Epox mobos) vary somewhat in exact dimensions, and here a few mm can obviously make a difference... I'm giving this post a bump to also ask about the MSI Geforce 4 4400/4600, which can be had pretty cheap and has a load of features/software included. Anyone tried it on an Epox 8KHA+?