I know that once you set the FSB above somewhere in the 125MHz range, this board does not shut down and restart properly but I also have a more annoying problem.
Lots of times when I shut the machine off via Shutdown... or change out some parts, when I try to boot the machine, it doesn't boot, nothing is displayed on the monitor (no signal) and the hard drive light is pegged on. This is very similar to the shutdown and restart problem above 125MHz FSB. I have to shut the computer on and off a few times and eventually it boots up (sometimes turning off the power to the powersupply does the trick). Any ideas?
Also, my Epson printer seems to take down my USB Hub when I try to print to it when I have my webcam or camera plugged in there too... maybe it is just drawing too much power (it is a powered hub). It works fine when I plug my printer in somewhere else. (This didn't happen on my previous computer).
Wondering if I have a defective motherboard or if this is just a few bugs in this relatively new motherboard. They are annoying.
Lots of times when I shut the machine off via Shutdown... or change out some parts, when I try to boot the machine, it doesn't boot, nothing is displayed on the monitor (no signal) and the hard drive light is pegged on. This is very similar to the shutdown and restart problem above 125MHz FSB. I have to shut the computer on and off a few times and eventually it boots up (sometimes turning off the power to the powersupply does the trick). Any ideas?
Also, my Epson printer seems to take down my USB Hub when I try to print to it when I have my webcam or camera plugged in there too... maybe it is just drawing too much power (it is a powered hub). It works fine when I plug my printer in somewhere else. (This didn't happen on my previous computer).
Wondering if I have a defective motherboard or if this is just a few bugs in this relatively new motherboard. They are annoying.