- Mar 15, 2005
- 302
- 0
- 76
A few weeks ago, while racking my barbell after a squat (on to a Valor squat stand that I use in home-gym), I missed the racking-rest on one side. The barbell crashed down on the safety stand, and got slightly bent. It's a 7-foot long, uniformly 1-inch diameter, standard bar (max weight capacity 300 lbs.).
Darn!
So, I mail-ordered another one that I thought would be identical. When I got it, it wasn't the same -- the ends were not threaded like my old bar. But, like my old bar, this bar weighs 19 lb. as well.
In the case of the old bar, I simply screw on a few extra nuts (that hold the weight plates) on either side until the bar is 20 lbs. But, the new bar is not threaded, and the one-inch dia nuts will not slide on to it.
So, what I need now are two half-pound plates with one-inch bores. Do such things even exist? My online searches have turned up nothing useful.
I definitely need some kind of a hack. Shaft collars (or washers) with 1-inch bore? The problem is that, while these things are available online, their weights are never mentioned in the specs.
Have any of you ideas that you could share with me?
Thanks, in advance.
Darn!
So, I mail-ordered another one that I thought would be identical. When I got it, it wasn't the same -- the ends were not threaded like my old bar. But, like my old bar, this bar weighs 19 lb. as well.
In the case of the old bar, I simply screw on a few extra nuts (that hold the weight plates) on either side until the bar is 20 lbs. But, the new bar is not threaded, and the one-inch dia nuts will not slide on to it.
So, what I need now are two half-pound plates with one-inch bores. Do such things even exist? My online searches have turned up nothing useful.
I definitely need some kind of a hack. Shaft collars (or washers) with 1-inch bore? The problem is that, while these things are available online, their weights are never mentioned in the specs.
Have any of you ideas that you could share with me?
Thanks, in advance.