Help with a slotket plz

[farns]

I am attempting to upgrade my Slot 1 mobo GA-6BXC
and pIII 450 with a 1gig Coppermine celeron and a slotket thats converst from slot1 to socket 370 fc-pga.
I am very new to computers and have not tried any type of replacing before,
my problem is that I removed the cpu fine and installed the slotket+cpu however teh cartridge is stuck to the original cpu with permanent plastic pins and without the cartridge the slotket is only held in place by the slot at its base and thus wobbles a little and looks precarious.
If I cut the pins on the cartridge I will render it pretty useless anyway, anyone done this procedure before?

 

[oldfart]

Yeah, sometimes the slocket will wobble like that. Do whatever you need to to firm it up.

 

[birddog]

I have rana few slot 1 boards like that before. The slot interface should be strong enough to keep the slotkit in place during normal use. If you move your computer, you may have to reseat the slotkit.

 

[farns]

Im sorry but I cant see if my motherboard supports the lower 1.75V of the Cu-mine celeron. It says auto-voltage detect in that url but cant see it saying in what range. Im sorry to be such a noob but would anyone be able to help?

Also my motherboard will only support 112fsb and 133 fsb overclocks so
A: What are the chances of a 1gig coppermine celeron getting 133 fsb stable ( I heard they topped out round 1.2ghz) and
B: If the above doesnt work do you know of any slockets that support 112fsb? Most seem to only support 66/100/133.

Finally, after looking at the latest BIOS on that url, I dont know if it supports anything past the 66mhz celerons so how high can I push the fsb?
How much will a 7200 rpm ATA100 rpm HD be handicapped? I think only ata66 support is offered in that BIOS.

Wether I get a whole new computer basically depends on wether a slocket fits or not