Mermaidman
Diamond Member
- Sep 4, 2003
- 7,987
- 93
- 91
Took some elbow grease, but I scored a display model (no pun intended ). Supposedly, there are two available in the
SHELBY, NC
store, but i highly recommend calling before anyone goes. The OM where I bought it would not give any further discount for the display model, so it's $300+$24tax-$70MIR-1%cash back and my valuable time. Thank you for finding this hot deal!
edit:
OMG--This LCD is awesome! No dead pixels. I cranked up UT2004--beautiful! No ghosting. NEC's website confirmed response time of 16ms on average. My only gripe is the shiny coating, which reflects light surfaces. OTOH, the shine makes it look really sharp! Guess I'll have to turn down the lights in the office.
Do follow the quick setup guide. I had to apply a lot of gentle force on the last step to get the display to vertical.
SHELBY, NC
store, but i highly recommend calling before anyone goes. The OM where I bought it would not give any further discount for the display model, so it's $300+$24tax-$70MIR-1%cash back and my valuable time. Thank you for finding this hot deal!
edit:
OMG--This LCD is awesome! No dead pixels. I cranked up UT2004--beautiful! No ghosting. NEC's website confirmed response time of 16ms on average. My only gripe is the shiny coating, which reflects light surfaces. OTOH, the shine makes it look really sharp! Guess I'll have to turn down the lights in the office.
Originally posted by: SpeedBrkr
I have a question regarding the lcd monitor.
If you look at the picture of the monitor on the box, the hinge that connects to the base is pretty high up (45+ degrees).
Now when I was setting mine up, I have it around 30 degrees. When the monitor is tilted perpendicular to the surface, it is just barely over half an inch above the table. In the picture on the box, the monitor is a good 2 and a half+ inches above the table.
Is the hinge just that stubborn? I tried exerting a little more force than normal but it won't budge anymore higher. I don't want to break anything, but should I just apply a lot more force to get it to move? It feels like the hinge is gunna snap if I do.
Even the Manual's Quick Setup Guide didn't show a diagram like the picture. =/
Can anyone shed some light on this?
Do follow the quick setup guide. I had to apply a lot of gentle force on the last step to get the display to vertical.