Hyper 48 Installation question

[imported_Sartori]

Hello

Heres an e-mail I sent to coolermaster about the installation of a hyper 48. Somethings not quite right with the supplied hardware for the installation. Was wondering if anybody has installed this yet...

I recently purchased a hyper 48 and had some questions about the installation. Its going on a p4 socket 478 Intel Motherboard D875PBZ. According to your instructions your suppose too replace the stock retention bracket with the included universal retention bracket and back plate. Thats not possible with the included universal retention bracket. It shows in the picture screwing the bracket down to the motherboard with 4 screws, which I assume screws the metal backplate to the motherboard at the same time. Theres no holes in your retention bracket to put the screws through to screw it and the metal backplate together.....
So its pretty hard to mount the bracket when theres no way to screw it to the motherboard.....

Any ideas??

 

[1336]

Are you intentionally replacing 'to' with 'too'? It's to hard too read. People will find it easier too take you seriously if you take the time too check your grammar. Plus, start using apostrophes.

 

[imported_Sartori]

Hello again,

Okay, the message has been edited. Sorry about the too's, its a bad habit I have. Been a long day at work and I get in a hurry when I type. Won't happen again.

 

[imported_Sartori]

Hello again

Sorry, but just wanted to bump this up again. I still have heard no word from Coolermast on these issues. Anybody out here installed this on a socket 478?

Thanks!!