I HATE COMPUTERS!!

[BenDare2]

My alarm goes off at 50C temperature..............you've got about all you gonna get til you cool that sucker down and get some pc133 ram...........
Don't look for no jumpers.....they ain't there..........****turn it off til it runs cooler than "70C"!!??!! You're already lucky......don't push it............


BTW........the 1.4 IS unlocked by the factory.....if it was locked you couldn't run it over 10.5.........you got it doing 13 now!! That's unlocked..................I'm gone........Ol'Ben

 

[DinoGucci]

updates: going to COMPUSA to buy a HSF and i might get ram.

 

[microAmp]

<< updates: going to COMPUSA to buy a HSF and i might get ram. >>



If you are going to try to use PC100 ram as PC133 go ahead and give up now. Get the PC133 RAM... then try to get the bus speed at the correct setting.

 

[DinoGucci]

went to COMPUSA , they didnt have anything good for HSF so i bought this stupid HSF supposably its 5000RPMS with a great HS made by antec. and still my temp didnt go down much. it stable at 60C instead of 70C now which is not bad. but i am lookin for a volcano 7+ to kool down and i am waiting on the pc-133 ram i am getting monday or tuesday hopefully.

 

[microAmp]

<< went to COMPUSA , they didnt have anything good for HSF so i bought this stupid HSF supposably its 5000RPMS with a great HS made by antec. and still my temp didnt go down much. it stable at 60C instead of 70C now which is not bad. but i am lookin for a volcano 7+ to kool down and i am waiting on the pc-133 ram i am getting monday or tuesday hopefully. >>



Got any RAM to borrow from a friend that is PC 133?

 

[DinoGucci]

UPdates : i got a stick of simpletech PC133 and the compusa heatsink+fan. plugged them in CPU TEMP is 37c not bad! i hit 1400 easily 10.5 X 133. (Case door not shut) i went up to 1543MHZ 11X133 no problems! went up 11X140 1591MHZ for a few hours , no problems! Covered the case, went to bed , got up , blue screen of wink2k shows on my monitor. went down to 1543 MHZ with 1.75v idle 43c. Next plan is SK-6 with the Ultra Delta Fan 60MM 8k RPM 50.13 CFM with some tweeking in the bios. but till i get the fan+hsink , i will play around with the bios tonight and i will let you guys know!
dino

 

[BlitzRommel]

Well, now we're getting somewhere.

See how a bit of patience and reading pays off?