I tried 2 MSI Master Slot 1 converter with PIII 700 on Tyan 1833DL but only one cpu is detected!

[IsOs]

This motherboard currently run dual Celeron 533 PPGA Celeron using the same MSI converter. When I tried 2 PIII 700 to replace the dual Celeron, only one cpu is detected by the motherboard. What is wrong? Has anyone use this motherboard with dual FCPGA PIII? Is this a problem with the MSI slot 1 converter?

 

[DieselMan]

Are you sure you are using the MSI Master V2.3 slockets and not something older?

Also, are both cpus cB0 stepping, and did you make sure you set both slockets to 100Mhz FSB? I know some other mobos had problem detecting 2 cpus if one of them was a cC0 stepping (due to different voltage lines).

 

[Von Ribbentrop]

You didn't mention it, so I'll ask. Did you set the jumpers on the MSI slotket that enables coppermine support and also the jumper that enables dual processor support.

Luck