Building a new system....it is a slow build, but ran into a problem. I have the Chaintech ZNF3-150, but have yet to purchase memory or processor, like I said...a slow build. Today I get in a NEC 8x DVD burner put it in the case and
it powers up, cool I think. So now I start routing the IDE cable to it, tried all 3 IDE ports, as soon as I plug in the
drive, it loses power. I was confused, tried another cable, different power connector, and different ports, all with
the same results. Take the DVD drive out of my running machine, and bam same thing when I hook it up, powers
up fine without IDE cable, dies with it plugged in. Now, I don't have a processor or memory in the board yet so this
may be the cause of the problem, I'm hoping someone says yes, but if not, did I receive a bad motherboard. Here
are the planned specs :
Chaintech ZNF3-150 have
2 x 512mb Mushkin 4000
A64 3200+
120 GB SATA Maxtor have
8x NEC DVD-+RW have
470w Enermax Whisper have
ATI AIW 9800 Pro
everything else I have is cosmetic so no need to bore you with that
Thanks
TIm
it powers up, cool I think. So now I start routing the IDE cable to it, tried all 3 IDE ports, as soon as I plug in the
drive, it loses power. I was confused, tried another cable, different power connector, and different ports, all with
the same results. Take the DVD drive out of my running machine, and bam same thing when I hook it up, powers
up fine without IDE cable, dies with it plugged in. Now, I don't have a processor or memory in the board yet so this
may be the cause of the problem, I'm hoping someone says yes, but if not, did I receive a bad motherboard. Here
are the planned specs :
Chaintech ZNF3-150 have
2 x 512mb Mushkin 4000
A64 3200+
120 GB SATA Maxtor have
8x NEC DVD-+RW have
470w Enermax Whisper have
ATI AIW 9800 Pro
everything else I have is cosmetic so no need to bore you with that
Thanks
TIm