Thanks guys. It wasn't that hard but if you decide to make one on your own, you should draft it first on paper. I had a hard time with the back panel as it had oddities, like the power supply, card slot and motherboard i/o connects. Also, cost wise it cost me alot. $60 for the acrylic and $40 for the cutting. Then the little things like the leds, power switch and fans/filters, corner connects, plastic glue, bumpers for the bottom, drive brackets, screwless side panel connects, screws, sandpaper, buffing stuff cost a total of over $150. I got my 3 panaflos from teamawe.com and the little things from Fry's Electronics. The plastic I got at Ridoutplastics.com near where I live. Locust I could have made it bigger but I fear of weight and cost. It took me a while to figure out exactly what size I wanted as they only sell the acrylic in 2x2,2x4,4x4. I got one 2x4 and a 2x2. It's the same dimensions as the Enlight 7237