Need help Overclocking P2-350 on a BH6

[Dramor]

Well I havent overclocked before and would like to try it on my system since i am planing upgradeing very very soon i'd like to take a wack at it on this system.

Well it's a
p2-350
128 Meg Ram 32/32/64 chips(probly generic)
Abit BH6-OK Ver 1.01

Since the multiplier is 3.5 i have to change fsb..
How do I figure what voltage is needed and what to run the agp/clk setting at?

I would like any sites that have info
also your tips
and what things besides the cpu are at risk of damage?

 

[they call mr big]

up the fsb slowly and test for a while to see if it's stable you might need to up the voltage a little to get it stable.

 

[spencer]

http://www.anandtech.com/showdoc.html?i=205 Check out Anands review of the BH6, about halfway down he explains the 'SEL100/66# Signal'.

 

[rigor]

i'd bump the voltage 10% (2.2V) and run it at 120-124mghz if your ram can stand it, the chip certainly can.

watch the temps on that chip too!

 

[CraigRT]

what are the chances a PII 350 can hit like 124 FSB? i woulda thought that was outta the question.. maybe we'll have to try this on my friends PII 350.. he has the same mo-bo.. 'cept i sold him 128 of Micron PC100.. so the RAM can handle it.

 

[Dramor]

I got It Stable to 392. 3.5x112 2.0v
Ran 3dmark through without crasing
Didnt go at 3.5x124 could be ram but i didnt up voltage yet thats next. I still dont unsterstang the 1/1 2/3
is that like
1/1 fsb@100=100 on AGP bus?
2/3 fsb@100=66 on AGP bus?

well back to messing around, My room is constanly Air conditioned and the case sides are always off. So I dont think heat is a problem yet but i'll run a prog to read the heat monitor hopefuly it is working cause it hasent leave 29c yet.

 

[rigor]

run the agp at 2/3 always!

124 needs: damn good pc-100 ram or pc-133
good vid card (geforce)