So my system has been running fine and dandy for quite some time... along the lines of over a year. Well, about a month ago or so, I wanted to see if there were any BIOS updates. Oh yeah, this is a DFI LanParty NF2 Ultra Rev. A board... Well I downloaded the BIOS update, I can't remember if, at the time, I thought I had a Rev. A or B board. Anyway, it wouldn't update the BIOS. So I tried a couple more. Well, one of them finally went through. Seemed to run fine... later on, wether it was that day or not I can't remember. I looked through my crap and saw that I did have a Rev. A. Well, the BIOS that it DID have WAS the most current for Rev. A. But, everything was fine so oh well.
Over the last week or so, it's been having issues. First, I realized it was only running the FSB at 100 mhz, instead of 200 (XP 3200+), so I increased FSB to 200. Ran fine.. until the next restart. The BIOS screen popped up, and said something along the lines of "Error detected.. reset to defaults." So it reset back to 100 FSB. I let it go.
And then today, I reset my computer to change back to 200 FSB, plus I wanted to play some Doom3 and the computer had been running for a few days. Anyway, I reset, and the screen never came back on. My monitor keeps switching between Analog and Digital (20" LCD), as if it's not getting a video signal. I cleaned the hell out of the case a while back, and everything seemed to be fine. Well, I checked EVERYTHING I could, and the computer will not POST. The "Diagnostic" LEDs on the board are useless, they are all ON, according to the manual meaning "Continue Booting" or something. I've reseat the video card, checked RAM, checked all connections.. everything's fine.
Oh, and I'm also getting NO error Beeps. Any clue?
Over the last week or so, it's been having issues. First, I realized it was only running the FSB at 100 mhz, instead of 200 (XP 3200+), so I increased FSB to 200. Ran fine.. until the next restart. The BIOS screen popped up, and said something along the lines of "Error detected.. reset to defaults." So it reset back to 100 FSB. I let it go.
And then today, I reset my computer to change back to 200 FSB, plus I wanted to play some Doom3 and the computer had been running for a few days. Anyway, I reset, and the screen never came back on. My monitor keeps switching between Analog and Digital (20" LCD), as if it's not getting a video signal. I cleaned the hell out of the case a while back, and everything seemed to be fine. Well, I checked EVERYTHING I could, and the computer will not POST. The "Diagnostic" LEDs on the board are useless, they are all ON, according to the manual meaning "Continue Booting" or something. I've reseat the video card, checked RAM, checked all connections.. everything's fine.
Oh, and I'm also getting NO error Beeps. Any clue?