Post your AMD FX-8350 Overclock

[Greenlepricon]

I ordered my 8320 but I'm waiting on my thermal paste to get here (gave my last tube to a friend) . It should be here by next week and I'll mess with this chip a little by then.

 

[Durvelle27]

I ordered my 8320 but I'm waiting on my thermal paste to get here (gave my last tube to a friend) . It should be here by next week and I'll mess with this chip a little by then.

what paste and cooler

 

[Greenlepricon]

The paste is MX-4 and the cooler is a Antec Kuhler H2O 620 with an extra fan for push/pull. I'm looking to find better fans though as I only had spare case fans lying around and they were pretty cheap.

 

[Durvelle27]

still pretty good cooling. should get some good clocks with that

 

[Greenlepricon]

I hope so. I'm going to try to get it as close to 5Ghz as possible even though it's a bit of a stretch

 

[Durvelle27]

I hope so. I'm going to try to get it as close to 5Ghz as possible even though it's a bit of a stretch

well 5GHz isn't hard to hit with the Vishera chips it really depends on your motherboard

 

[joshhedge]

was at 5.1GHz but it got to toasty so now it sits at 4.81GHz until i get a water cooler

What are your temps like at 5.1 and 4.81 respectively?

 

[Greenlepricon]

well 5GHz isn't hard to hit with the Vishera chips it really depends on your motherboard

Oh I'm not too familiar with what these chips can do yet. I haven't done too much research but either way I'll see what I can do with mine and post the results.

 

[Durvelle27]

What are your temps like at 5.1 and 4.81 respectively?

at 5.1 was seeing temps around Idle:60C+ and 4.8 Idle:40 and Load:61c

 

[guskline]

at 5.1 was seeing temps around Idle:60C+ and 4.8 Idle:40 and Load:61c

Have you run IntelBurnTest, AMD OC stability test of OCCT to check stability? BTW those are very high clocks for air.

 

[T_Yamamoto]

5ghz at 60c? No thanks.

 

[guskline]

I fooled around with IBT, AMD OD stability test and OCCT and decided I wanted my rig to pass all three as follows: IBT at least 20 runs and AMD OD stability test the recommended 1 hr with all components tested and OCCT for the recommended 1 hr with no errors. Rig three below at stock voltage at 4.334 Ghz (20 x 217) passes all three. When I start to raise the multiplier above the 20 I have to increase voltages and thus power and heat to get more stability. I'm going to do some fine tuning to get my rig to 4.5 ghz. I'd rather have a bit slower and cool than try the 4.8Ghz gig with high heats and questionable stability.

 

[Durvelle27]

Have you run IntelBurnTest, AMD OC stability test of OCCT to check stability? BTW those are very high clocks for air.

Nawl used Prime95 for 3hrs and yes ik there high clocks but 4.8 is just fine as volts aren't that high so not as bad as 5GHz

 

[Idontcare]

Nawl used Prime95 for 3hrs and yes ik there high clocks but 4.8 is just fine as volts aren't that high so not as bad as 5GHz

1) What is a good mobo for OC'ing 8350's?

2) Can the lid be removed?

I suddenly find myself in need of a cpu :hmm:

 

[MegaWorks]

1) What is a good mobo for OC'ing 8350's?

2) Can the lid be removed?

I suddenly find myself in need of a cpu :hmm:

Asus Crosshair V Formula/Formula-Z :biggrin:

 

[BD231]

Poor vrms, I wonder how long a motherboard could withstand that kind of draw.

 

[Idontcare]

Asus Crosshair V Formula/Formula-Z :biggrin:

All right! You twisted my arm and convinced me to give it shot.

Time for IDC to get him some AMD

Ordered.

PS - expect me to be hitting you up for OC'ing pointers

 

[ShadowVVL]

vary nice IDC, I cant wait to see what frankenstein like things you will do with it.

 

[Shamrock]

All right! You twisted my arm and convinced me to give it shot.

Time for IDC to get him some AMD

Ordered.

PS - expect me to be hitting you up for OC'ing pointers

You could have gotten a combo deal, with the ASUS SABERTOOTH 990FX R2.0 for $386.98

In the OC club @ overclock.net a few have these mobos.

Just for reference: http://www.overclock.net/t/1318995/official-fx-8320-fx-8350-vishera-owners-club

 

[Greenlepricon]

All right! You twisted my arm and convinced me to give it shot.

Time for IDC to get him some AMD

Ordered.

PS - expect me to be hitting you up for OC'ing pointers

Looking forward to this! That way I'll actually know what I'm doing when I overclock

 

[BD231]

Hopefully u get reimbursed for that garbage.

 

[jvroig]

Hopefully u get reimbursed for that garbage.

There was absolutely no need for that. Please avoid inflammatory postings like that, as it serves no purpose other than trolling or inciting flame wars.

Let this thread remain what it is - a place for 8350 owners to post their overclocks and discussions around it.

 

[hokies83]

Well the 5ghz mark...

It seems ppl are pushing limits of these chips heat and Vcore wise to it's limits We just have to see if Vishera chips can handle the Abuse for any extended period of time.

Yes i know i have my IB at a high Vcore.. but im also 25 c from TJ Max..

 

[joshhedge]

Nawl used Prime95 for 3hrs and yes ik there high clocks but 4.8 is just fine as volts aren't that high so not as bad as 5GHz

What water CPU cooler are you going to get and what TIM do you use at present?

 

[Soulkeeper]

Have there been any reviews showing total system power usage when underclocked/undervolted ?

google and searching the forum is showing nothing for this, which seems odd to me