Originally posted by: Core2
Originally posted by: AZDude
Couple of questions here
1) My temps seem to be a little high, http://usera.imagecave.com/bear254/2.6IDLE.JPG . Is this with in the recommended temp range or am I to hot? I have a 120mm fan bringing in air from the front, an 80mm fan blowing in from the side and a 120mm pushing air out the back. I also have this HSF on the NB http://www.newegg.com/product/product.asp?item=N82E16835116018 and a HS on the SB.
2) Looking at the screen shot above, I have the following set in the BIOS Vcore@1.33125, but on Speed Fan and Probe II it shows at 1.30 or 1.31. Do these programs show what the CPU is using or what the BIOS is set for?
Thanks
I like your NB heatsink. How is working out? Does it get real hot to the touch? Make sure that the push pins on the Freezer7 are in all the way. Try to rotate it a little while pushing down wards. Then check for any slack in the pins and that it isn't hung up on anything.
CPU temps are not bad MB temps are rather high. What is your ambient air temp? How many days has the HFS been on? The MX-1 that is pre-applied takes about 3- 4 weeks to cure. I hope you didn't take it off and put something else on.
The NB HSF is hot right now, I can touch it but only for a few minutes. (but I just got home and I had ran an orthos test for 2 hours 31 minutes)
I checked all the pins on the freezer pro7 and they are set good. I did take the MX-1 off before, but I bought some more and reapplied it yesterday.
The ambient temps in the office (where the computer is) is between 75 and 80 degrees.