Unusual Voltage reading with CPUZ

[chneff72]

Still working out the kinks on my new set up, and ran CPUID Hardware Monitor to peek at things.

Says that my voltage is out of whack. Any ideas or think it's just a CPUID issue?

Setup in Sig - thx

--------------Paste------------------



ITE IT87 hardware monitor

Voltage sensor 1 3.04 Volts [0xBE] (VIN1)
Voltage sensor 2 3.41 Volts [0xD5] (+3.3V)
Voltage sensor 3 5.00 Volts [0xBA] (+5V)
Voltage sensor 4 4.86 Volts [0x4C] (+12V)
Voltage sensor 5 -10.50 Volts [0xA4] (-12V)
Voltage sensor 6 -10.88 Volts [0xAA] (-5V)
Voltage sensor 7 4.97 Volts [0xB9] (+5V VCCH)
Voltage sensor 8 3.33 Volts [0xD0] (VBAT)

 

[starfireone]

What version of cpuid are you running? You might be right, it
could be an cpuid issue.

 

[chneff72]

thx for the response. Using CPUZ 1.51

 

[lopri]

Hello,

I get similar readings on my 790X board as well. Software readings can be accurate or inaccurate, but in a case like this they are very likely a bogus reading. I wouldn't worry to much.

Welcome to AnandTech Forums.

 

[theAnimal]

If you want to be sure you need to use a DMM.

 

[lenjack]

Your comouter wouldn't run with such a low 12v. The -5v is irelevant since modern computers don't use this. Some power supplies don't even have a -5v line.