- Jun 13, 2004
- 118
- 0
- 0
Recieved the xp-120 the other day
and am happy to say its fits the a8v with no probs
I lapped the xp-120 base down to the copper. While sanding, I found the base was a little convex, and the nickel finish was definatley a bit of a bear to sand off, but it can be done.
With my setup the following results:
slk-948u
56cfm 35db fan
idle 34
load 52
xp-120
69cfm 35db fan
idle 31
load 44
All results using AS5, the xp-120 results are on a fresh install so temps may drop a bit more...
I am awaiting some Sanyo Denki 105cfm 39db fans , I'll update this thread when they get here.
I also tried using a gutted 120mm x 38mm fan as a spacer between my 120mm fan and the xp-120 to try and lessen the dead zone in the direct center of the fan. Temps didn't seem to change at all, but the sound went up quite a bit. I imagine it was due to the convex sides of the gutted 120mm messing up the airstream.
Definatley a top notch heatsink, and my slk-948u was no slouch, and besides mounting my 110cfm 92mm delta on my slk, there would be no way to match its performance and have a reasonably quiet case.
Iron
and am happy to say its fits the a8v with no probs
I lapped the xp-120 base down to the copper. While sanding, I found the base was a little convex, and the nickel finish was definatley a bit of a bear to sand off, but it can be done.
With my setup the following results:
slk-948u
56cfm 35db fan
idle 34
load 52
xp-120
69cfm 35db fan
idle 31
load 44
All results using AS5, the xp-120 results are on a fresh install so temps may drop a bit more...
I am awaiting some Sanyo Denki 105cfm 39db fans , I'll update this thread when they get here.
I also tried using a gutted 120mm x 38mm fan as a spacer between my 120mm fan and the xp-120 to try and lessen the dead zone in the direct center of the fan. Temps didn't seem to change at all, but the sound went up quite a bit. I imagine it was due to the convex sides of the gutted 120mm messing up the airstream.
Definatley a top notch heatsink, and my slk-948u was no slouch, and besides mounting my 110cfm 92mm delta on my slk, there would be no way to match its performance and have a reasonably quiet case.
Iron